Cloverdale Roofing Contractor
Roof & Gutter Busters, Inc. is a family-owned roofing and sheet metal contractor based in Rohnert Park, about 30 miles south of Cloverdale on Highway 101. We have installed gutters across Sonoma County since 2006 and provided full roofing services since 2014. California license #988438, classifications C-39 Roofing and C-43 Sheet Metal.
Cloverdale sits at the north end of Sonoma County, and roofing there is not the same proposition as roofing in Rohnert Park or Petaluma. The city runs its own building department with its own rules, the summers are hotter than anywhere on the coastal side of the county, and the wildfire exposure is on a different level. This page covers what that actually means for a roof.
Cloverdale's roofing rules are stricter than the county's
This is the single most important thing for a Cloverdale property owner to know, and almost nobody quotes it correctly.
In unincorporated Sonoma County, a Class A roof assembly becomes mandatory when more than 50 percent of a roof is re-roofed. Cloverdale has historically applied a far lower threshold — Class A materials or assemblies when 25 percent or more of a roof is replaced within a one-year period.
That comes from Appendix D of the Sonoma County Reroofing Guidelines, which Cloverdale participated in developing alongside the county, the other city building departments, and the Independent Roofing Contractors of California, Northbay Chapter.
The practical effect: a job that would be a straightforward partial repair under county rules can trigger the full Class A requirement inside Cloverdale city limits. A quarter of a roof is not much. Storm damage to one slope can get you there.
Verify before you plan around this. The Sonoma County Reroofing Guidelines document dates from July 2008 and references earlier code cycles, and the City of Cloverdale adopted updated building codes in 2019 under Ordinance 732-2019. The 25 percent threshold may have changed. Confirm the current requirement with the City of Cloverdale Building Department at (707) 894-1701 before committing to a scope — or let us confirm it as part of the estimate, which is what we do on every Cloverdale job.
Cloverdale also requires attic ventilation at final
Cloverdale is called out by name in the same guidelines on this point: the city requires code-complying attic ventilation before granting final approval on re-roofing work. If your existing attic ventilation is undersized — common on older homes — that becomes part of the reroof rather than a separate project discovered at the final inspection.
Cloverdale runs its own building department
Cloverdale is an incorporated city, so reroofing permits go through the city, not Permit Sonoma. Two things worth knowing:
- City of Cloverdale Building Department, 126 N. Cloverdale Blvd., Cloverdale, CA 95425 — (707) 894-1701.
- If the work changes the building's exterior appearance, the Planning Department may need to approve it before the work starts. For a straight replacement in kind this rarely applies; for a change of material, color or profile — and particularly downtown — it can.
Sources: Sonoma County Reroofing Guidelines (July 2008) · City of Cloverdale Building Permit Submittal Requirements
Wildfire and your roof in north county
Cloverdale's fire history is not abstract. The Cloverdale Fire Protection District's Community Wildfire Protection Plan records 12 large wildfires of more than 500 acres since 1878, with recent fires concentrated on the eastern side. The most recent major one in the district was the Pocket Fire in October 2017, which burned roughly 17,400 acres in total and primarily affected the southeastern area.
About 5 percent of the district sits inside the Wildland Urban Interface, but roughly 55 percent falls within the wildfire influence zone as designated by CAL FIRE in 2019. Separately, CAL FIRE released updated Fire Hazard Severity Zone maps for Sonoma County on February 24, 2025, so your parcel's designation may have changed since the last time you looked.
The roof is the most common structural fuel for ember-caused ignition. Roof ignitions frequently come from fires more than half a mile away, and wind can carry firebrands over a mile from the source. The roof assembly and its resistance to ember penetration matter as much as the surface material.
Two things follow from that, and the second one is cheap.
First, the assembly matters more than the shingle. Class A describes a tested system, not a product. Buying a Class A-rated shingle and installing it outside its listing does not give you a Class A roof. Qualifying options include asphalt shingle systems, metal, concrete and clay tile, slate, synthetics and hybrid composites.
Second, embers get in through vents. The CWPP specifically encourages owners of existing homes to fit fine wire mesh over attic and foundation vents — a small upgrade that addresses one of the most common ignition paths. We fit ember-resistant vent screening as part of reroofing work, and it is worth asking about even if you are not replacing the roof.
Worth knowing: only structures built or substantially remodeled since 2008 are likely to meet current Chapter 7A ignition-resistance standards. A good deal of Cloverdale's housing stock predates that.
Source: Cloverdale Fire Protection District Community Wildfire Protection Plan · Permit Sonoma, CAL FIRE Fire Hazard Severity Maps
Cloverdale roofs and what they need
The 2020 Census counted 3,365 occupied housing units in Cloverdale, with a median home value of $476,100. In practice that is a town of mostly older single-family housing, a historic downtown core, and rural and hillside property on the edges — three quite different roofing problems.
- Older in-town housing — composition shingle on simple roofs, frequently on a second or third replacement, often with spaced sheathing underneath that has to be addressed before a modern shingle can go on.
- Downtown and historic buildings — where exterior appearance changes may need Planning approval, and where profile and color matter.
- Rural and hillside parcels — the properties most exposed to ember travel, most likely to be in a high or very high hazard zone, and where the Class A assembly question is not a formality.
- Agricultural and vineyard outbuildings — metal and low-slope spans in the Alexander Valley corridor, usually with drainage that was never designed for the rain the last few winters have produced.
Layering: what you can and cannot roof over
A common Cloverdale question, because tearing off costs money. The general rules under the reroofing guidelines:
- No more than one overlay of composition shingles over original composition or wood shingles.
- Complete tear-off is required where the existing roof already has two or more layers of any covering.
- Tear-off is also required where the existing covering is wood shake, slate, clay, cement or asbestos-cement tile, or where the deck is water-soaked or deteriorated.
- Tile roofs permit no overlay at all.
- Composition shingle requires solid sheathing. Filling in between existing spaced sheathing boards is not allowed for composition shingle re-roofing, and 3/8-inch panel is not an acceptable sheathing thickness.
- New roof sheathing requires a nailing inspection.
On top of all of that, in Cloverdale the 25 percent threshold means an overlay on part of a roof may still pull you into Class A territory. We check it before quoting rather than after.
What we do in Cloverdale
- Roof replacement and reroofing — asphalt and composition shingle, metal, wood shake, flat and TPO membrane, installed as listed Class A assemblies where required.
- Roof repair and leak diagnosis — including storm damage, with insurance claims welcome.
- Roof inspections — free, and including a check of your current fire hazard designation and the applicable Class A threshold.
- Seamless gutters and downspouts — aluminum, steel and copper, fabricated in-house under our C-43 sheet metal classification, plus gutter guards.
- Gutter cleaning — which in a fire-exposed area is not only a drainage issue; accumulated dry debris in a gutter is an ember catch.
- Roof moss removal — soft-tool removal and treatment, never pressure washing, which strips the granules off composition shingles and shortens the life of the roof.
- Skylight installation and replacement, including flashing and surrounding roof work.
Licensing, certification and warranty
| Item | Detail |
|---|---|
| California license | #988438 — C-39 Roofing, C-43 Sheet Metal |
| Manufacturer certification | GAF Certified contractor |
| Workmanship warranty | 20 years on our labor, separate from any manufacturer material warranty |
| Insurance | Licensed and insured; insurance claims welcome |
| In business | Gutters since 2006, roofing since 2014 |
| Ownership | Family owned and operated — Everardo and Yoli Zuniga |
| Languages | English and Spanish — se habla español |
You can verify any California contractor's license, including ours, at the Contractors State License Board. Only a contractor holding a C-39 classification can pull a reroofing permit on your behalf.
Free roof inspection and estimate in Cloverdale
(707) 584-3010Roof & Gutter Busters, Inc. — 6050 Commerce Blvd, Suite 200, Rohnert Park, CA 94928
Cloverdale roofing questions
Do you actually serve Cloverdale, or just claim to?
We serve it. We are based in Rohnert Park, about 30 miles south on Highway 101, and Cloverdale is inside Sonoma County and inside our service area. We will tell you honestly at the inspection if a job is too small to justify the drive, rather than pricing it so you say no.
Does Cloverdale really require Class A at 25 percent?
That is the threshold recorded in Appendix D of the Sonoma County Reroofing Guidelines, which Cloverdale helped develop — notably lower than the county's 50 percent. The document dates from 2008 and the city updated its building codes in 2019, so confirm the current figure with the City of Cloverdale Building Department at (707) 894-1701. We confirm it on every Cloverdale estimate.
Can I roof over my existing Cloverdale roof?
Only if it currently has one layer, that layer is composition or wood shingle, the deck is sound and dry, and the scope does not cross the Class A threshold. Two existing layers, or any wood shake, slate, clay, cement or asbestos-cement tile, requires a full tear-off.
Will I need to fix my attic ventilation too?
Possibly. Cloverdale requires code-complying attic ventilation before granting final approval on reroofing work. We assess existing ventilation at the inspection so it is in the estimate rather than a surprise at final.
Is my Cloverdale property in a fire hazard zone?
Roughly 55 percent of the Cloverdale Fire Protection District falls within CAL FIRE's wildfire influence zone, and CAL FIRE updated Sonoma County's Fire Hazard Severity Zone maps in February 2025. We check your parcel's current designation as part of the inspection, because it affects what you are allowed to install.
What is the cheapest thing I can do to reduce ember risk?
Fine wire mesh over attic and foundation vents. The Cloverdale Fire Protection District's wildfire plan specifically recommends it for existing homes, and it addresses one of the most common ways embers get into a structure. Keeping gutters clear of dry debris is the other.
Do you speak Spanish?
Yes. Se habla español.
Roof & Gutter Busters, Inc.
6050 Commerce Blvd, Suite 200, Rohnert Park, CA 94928
(707) 584-3010 · CA License #988438 (C-39 Roofing, C-43 Sheet Metal)
Family owned and operated. Serving Cloverdale and all of Sonoma County, plus Napa and Marin. Se habla español.
Code, permitting and wildfire information on this page is summarized from City of Cloverdale, Sonoma County and Cloverdale Fire Protection District publications and is provided for general guidance. Requirements change — confirm current requirements for your address with the City of Cloverdale Building Department before starting work.